I have a Bosch 5412L 12" sliding miter saw. It makes a high squeal noise when you start it up. It only does this on start up. Any idea as what it could be?
I have a Bosch 5412L dual bevel compound slide mitersaw and I am having problems aligning the blade. I bought it used and had to replace the blocks in the slide, but I still cannot get the blade to adjust to run true. It always cuts at a slight bevel, can anyone give me some advise on how to adjust it correctly?...
Read this post in the
forums
I have a Bosch 5412L saw and when I pull the power trigger nothing happens. It's a relatively new saw. I took the handle apart where the trigger is and noticed that the switch has a black, white and gray wire attached to it.
With the switch off:
* black wire has 124V
* white wire 0V
* gray wire 0V
With the switch on:
* black wire has 124V
* white wire 124V
* gray wire has 0V
From the wiring diagram found on this site, it looks like the gray wire goes to the stator, the white goes to the stator then another white wire goes from the stator to the armature.
Is the gray wire suppose to have voltage with the trigger ON? It seems to me that it must or what else would it be used for?
Just want to make sure that sounds like the problem before I buy a part I don't need.
Page A 
Page B 
Page C 
_WW_1.gif)
