Repair Parts Home Power Tool Parts Bosch Parts Bosch Miter Saw Parts
Bosch 3915 (0601475039) 10 Inch Slide Miter Saw Parts
Quick Fix: How to Replace the Blade on a Miter Saw
This article shows how to replace a miter saw blade on a saw with or without a blade lock.
How to Diagnose a Bad Power Cord or Switch
This article outlines the basics of power tool and appliance electrical diagnosis. You can use a multimeter to test tool and appliance cords and switches, the two parts usually responsible for electri...
How to Adjust a Miter Saw
Miter saws often need their bevel angles and miter angles adjusted, and this article explains generalized steps to make these adjustments on most miter saws.
Power Tool Care and Maintenance 101
This article suggests guidelines for power tool care and maintenance. It also describes information tools available at eReplacementParts.com.
Discussion for the Bosch 3915 (0601475039) 10 Inch Slide Miter Saw
Post a Comment
Ask a question, answer a question, or post a comment!
Question: Lock Lever For Bosch Miter Saw
Is there an aftermarket lock lever available for this discontinued item?
Reply: Lock Lever For Bosch Miter Saw
Although the manufacture has discontinued the 2610911559 Lock Lever. I did some searching on line an it looked as if there were a few out there. Hope you can locate one.
Question: Miter Saw Brush Holders
The handle broke on my Bosch 3915 miter saw and I need to replace the motor housing. I ordered a new housing and now need to swap or install new brush holders. Can the existing brush holders be removed from the damaged housing or do I need to order new ones?
Reply: Miter Saw Brush Holders
The brush holders can be taken out of the old housing. But for the life of me I can't remember how they are held in place, they might even be pressed in. Hopefully someone knows more details.
Question: Bosch 3915 Miter Saw
My Bosch 3915 miter saw is burning brushes at an accelerated rate. A lot of arcing at the brush and commutator. Removed armature and took to motor shop. They cleaned up commutator and said armature is ok, but still burns brushes quickly. Any suggestions. Thanks. Robert.
Reply: Bosch 3915 Miter Saw
Could be bearings are bad. Check fit in housing and make sure there is no play between bearing and housing.
Also check the brush holders and springs. Make sure brush holders are square and straight.
Review: Bosch - 3915
I have owned this tool for 10 years. It was used daily in a small commercial cabinet shop. Now it travels to the jobsite in and out of the back of a pick-up. Its a little stiff...but still spot on accurate. I use it to cut all the finish material for custom cabinetry installations. the blade guard finally wore out but the rest works perfectly. very well built. I would recommend this tool.