Repair Parts Home Power Tool Parts Black and Decker Parts Black and Decker Miter Saw Parts
Black and Decker 1703-1 Type 2 10 Miter Box Saw Parts
Quick Fix: How to Replace the Blade on a Miter Saw
This article shows how to replace a miter saw blade on a saw with or without a blade lock.
How to Diagnose a Bad Power Cord or Switch
This article outlines the basics of power tool and appliance electrical diagnosis. You can use a multimeter to test tool and appliance cords and switches, the two parts usually responsible for electri...
How to Adjust a Miter Saw
Miter saws often need their bevel angles and miter angles adjusted, and this article explains generalized steps to make these adjustments on most miter saws.
How to Remove an Armature Bearing with a Vise
This article explains one backup method for removing armature bearings when a bearing puller isn't available.
Discussion for the Black And Decker 1703-1 Type 2 10 Miter Box Saw
Post a Comment
Ask a question, answer a question, or post a comment!
I need to replace part number 24 (from diagram) on our saw model 1703-1 I did not see it on the list, can i get this part
Unfortunately the manufacture no longer supplies the guard for this saw. You can keep searching on line to see if you are lucky enough to locate one.
Question: Part No. 132254-07
Does I have to order the brush and holder separately? Discription indicates "Sold Individually"
Reply: Part No. 132254-07
If you order part number 132254-07 you will receive one brush and one brush holder. This is a part that sold individually so you will probably want to order two since there are two brush & holder assemblies per tool.
Hope this helps,
Question: Black & Decker Saw Dust Coll...
Need replacement for B & D part # BT 100 for model 1703-1 type 2 miter saw. No longer available from you or Black and Decker..Such a common part should be available from another source I would think. The outlet Diameter is 1-5/8" so a simple hose clamp would be all that is needed to hold a bag that has a large enough inside diameter to go over the outlet.
Please advise of source(s) if you can? Thanks,
Ted J., retired in Sedona, AZ
Reply: Black & Decker Saw Dust Coll...
You might try looking at a part number 900242. It uses a wire to clamp around the exhaust on the saw.
Accessories for the 1703-1