Discussion for the Bolens 13AM762F065 (2008) Lawn Tractor
Post a Comment
Ask a question, answer a question, or post a comment!
Question: The Bolt That Holds The Blade On...
do I have to change the entire spindle or is there another way to fix it?
Reply: The Bolt That Holds The Blade On...
You may get away with just ordering the 712-0417A Hex Flange Nut 5/8-18 Thread. But you may want to get a thread chaser and clean up the threads on the spindle. If that doesn't work you may need to go with the complete 918-04474B Spindle Assembly, With Pulley. Note: The new spindle assembly does not include a new blade bolt.
Question: Engine Dies After About 45 Minut...
'08 Bolens 15.5 HP. The engine runs fine for about 45 minutes then just quits like it ran out of gas. Changed coil still the same thing, changed carb still does the same. Pulled screw from bottom carb bowl and no gas, new filter and over 1/2 tank of gas. Let sit for a couple of hours and will run for about 45 minutes and quits again. Any ideas??
Question: Bolens Rider Mower
once the 9/16 bolt is removed does it come straight off? or is it screwed in the steering shaft?
Reply: PTO Pulley Screw
Speaking to the manufacture, they are telling me that the 710-04607 is a standard thread.
Hope this helps,
Question: Deck Engage/disengage
My blades will not disengage. When I pull the lever back it doesn't seem to have any tension. What could be my problem?
Reply: Deck Engage/disengage
The cable is similar to a brake cable on a bike. Two possible reasons: 1. the cable is stretched..so it is not allowing the brake pad to make connection to the pulley. 2. the cable could have been bent or cut.
These 2 things happened to mine. Hope this helps out.