Washer 014030

Replaced bearings and installed new washers, spacers and bolts according to parts list

I used an Allen wrench used to remove the covers the gears. I removed and replaced the old parts with the new and then put it back together.

1. Removed old bushings.
2. Inserted new bushings. Had to press and hammer into place. Bushings were a tight fit.

Took off the old pedal arm sleeve, both crank bushings, the large axle cover, and the M8 washer by unscrewing the M8x30mm button screw with a screwdriver. I inspected all of the parts. The pedal arm sleeve and large axle cover were worn through (plastic shavings everywhere!), and it looked like the outside crank bushing was damaged. So, I replaced these 3 things, and the M8 washer, putting everything back on the crank. I tightened the button screw. Done! Everything seems to work fine. I am a little worried that there still seems to be quite a bit of plastic shavings being created by all of the rubbing/friction. Not sure if this is normal, but if it wears through again, at least I now know how to fix it.