This is an OEM sourced replacement part used on a variety of Handheld Trimmers and Blowers/Vacuums. Switches are a commonly replaced part in power tools, handling on/off operations. Because switches use mechanical internals, they will degrade and wear out over time, eventually requiring replacement. It has a plastic body and it is sold individually.

To replace this switch you would need a Screwdriver.

• First make sure the tools is not plugged in
• Then you want to remove screws used to hold two pieces of housing set together
• Disconnect wires from the old switch and remove it from the housing
• Place the new switch in the housing and connect wires to it
• Reassemble the housing

This is a Genuine Manufacturer Sourced replacement part used on a variety of Lawn and Garden Equipment. This item is Metal an is Sold Individually. A lock nut is a type of nut that resists loosening when properly threaded onto a bolt.

This is a Manufacturer Approved replacement nut for lawn and garden equipment. This item is Metal an is Sold Individually. A lock nut is a type of nut that resists loosening when properly threaded onto a bolt.

This is an OEM replacement part and is sold individually.
Its propose is to deliver an electric current from an ignition system to the combustion chamber of a gas fueled engine.
It will ignite the air fuel mixture by the spark.
Spark Plugs will usually have to gapped to the manufactures specifications found in the owners manual.

Over time a Spark Plug will become fouled because the air/fuel ratio may be set wrong,worn piston rings, carbon build up and other factors.
It is better to replace a fouled spark plug, rather then trying to clean it.

This is a genuine OEM sourced replacement part used on gas trimmers/edgers. The purpose of this part is to mix air and gas before the fuel mix goes to the engine.

If the engine won't start and the tank is full of fresh fuel, test the carburetor by removing the air filter and pouring about a teaspoon of fuel into the carburetor. Pull the starter rope. If the engine starts and then quickly dies, the carburetor is likely the problem.

This is a metal body carburetor, it is sold individually. This assembly includes fuel lines, primer bulb. You will need a screwdriver to perform this repair.

This is the Genuine Manufacturer Sourced replacement Drive Belt that drives the transmission which propels the lawn mower wheels. This part is made out of Rubber and it is Sold Individually. Clean the pulleys off before installing the new belt to ensure top performance and longevity with your new belt. Inspect belts periodically and replace them when worn to maintain peak performance.