Spring Throttle Lever Return V452000480
Part Number: V452000480
Order within the next 48 minutes
and your part ships today!
and your part ships today!
*This part replaces obsolete part #: 72435-12750.
Product Information
Compatibility
Products Compatibility
This item works with the following types of products:
- • Edger
- • Trimmer
Repair Guides
![]()
Articles:
|
Filthy Filters? This article will show you how to install a filter kit on an Echo SRM-225 trimmer....
May 27, 2015
|
Questions & Answers for Spring Throttle Lever Return
No questions have been asked yet
Repair Instructions: Submitted by Customers Like You
Tool Type:
Trimmer
Parts Used:
Repair Difficulty:
Easy
Time Spent Repairing:
30-60 minutes
Tools Used:
Screwdriver, Adjustable Wrench, Needle nose pliers
Plastic throttle body broke after 23 years service.
I removed the broken plastic throttle body. I also wanted to replaced worn throttle cable. I replaced the cable and installed the new throttle body and switch. I also wanted to replace the rubber handlebar plug which has been missing for several years.
My 23 year old Shindawia is now back in service and operates like new.
The replacement parts were original equipment parts. They are exactly like the original parts that I replaced. I was so happy to be able to locate them and get my weedeater back in service. Thank you!
My 23 year old Shindawia is now back in service and operates like new.
The replacement parts were original equipment parts. They are exactly like the original parts that I replaced. I was so happy to be able to locate them and get my weedeater back in service. Thank you!
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Tool Type:
Trimmer
Parts Used:
Repair Difficulty:
Easy
Time Spent Repairing:
30-60 minutes
Tools Used:
Screwdriver, Nutdriver, Silicone spray lube
throttle cable "stiff" and would not return to idle.
Loosen two screws on throttle lever assy, loosen two screws on power head-to-trimmer tube clamp. Twist and slide power head off tube. Coated new grip inside with silicone spray and slide onto tube. Slide power head onto shaft and engage drive shaft, retighten clamp screws. Install new cable and spring. NOTE: found it best to route new cable and kill wires thru new grip channel before sliding new grip onto shaft! Also clean and lube anything that needs attention during tear-down always makes reassembly much easier.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Product Information
Repair Guides
![]()
Articles:
|
Filthy Filters? This article will show you how to install a filter kit on an Echo SRM-225 trimmer....
May 27, 2015
|
