Product Information
Description:
This is an original part from Hitachi. The spring (e) is made for use with several compound saws. The metal spring is fitted between the stopper components, providing the required tension. This item is sold individually. You will need a Phillips screwdriver and needle-nose pliers for the proper replacement. |
Frequently Purchased With
Compatibility
the 20 compatible machines
This part is compatible with the following machines:
Metabo HPT (Hitachi)
C12LSH 12" Sliding Dual Compound Miter Saw
C12LSH 12" Sliding Dual Compound Miter Saw
C12RSH 12" Sliding Dual Compound Miter Saw
C12RSH 12" Sliding Dual Compound Miter Saw
C8FSE Slide Compound Saw
C8FSHE Slide Compound Saw
C10FSH Slide Compound Saw
C10FSB Slide Compound Saw
C10FSBSM 10-Inch Sliding, Dual Compound Miter Saw 12 Amp 3800 Rpm 5/8 Inch Arbor W/O Laser
C10FSHSM 10-Inch Sliding, Dual Compound Miter Saw With Laser Marker W/Laser 12 Amp 3800 Rpm 5/8 Incharbor
C12LSH 12" Sliding Dual Compound Miter Saw
C12RSH 12" Sliding Dual Compound Miter Saw
C12RSH 12" Sliding Dual Compound Miter Saw
C8FSE Slide Compound Saw
C8FSHE Slide Compound Saw
C10FSH Slide Compound Saw
C10FSB Slide Compound Saw
C10FSBSM 10-Inch Sliding, Dual Compound Miter Saw 12 Amp 3800 Rpm 5/8 Inch Arbor W/O Laser
C10FSHSM 10-Inch Sliding, Dual Compound Miter Saw With Laser Marker W/Laser 12 Amp 3800 Rpm 5/8 Incharbor
Products Compatibility
This item works with the following types of products:
- • Miter Saw
- • Saw
Questions & Answers for Spring (e)
No questions have been asked yet
Repair Instructions: Submitted by Customers Like You
Tool Type:
Miter Saw
Repair Difficulty:
Medium
Time Spent Repairing:
1-2 hours
Tools Used:
Screwdriver, Socket set
Dropped by movers - bent bolts and broke stopper.
1. Replaced slide arm bolts and secure slide arm.
2. Remove table inserts from turn table
3. Remove shaft bolt
4. Remove turn table from base.
5. Remove stopper cover
6. Replace stopper and spring and put cover back on.
7. Replace liner on bottom of turn table
8. Reassemble
2. Remove table inserts from turn table
3. Remove shaft bolt
4. Remove turn table from base.
5. Remove stopper cover
6. Replace stopper and spring and put cover back on.
7. Replace liner on bottom of turn table
8. Reassemble
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Product Information