Product Information
Description:
This is a genuine Ryobi replacement part that is sourced from the original manufacturer to be used with table saws. The special set screw is used to fasten the holder plate to the guide bar on the sliding miter table. This set screw is available as an individual replacement part, please see illustrated part list for associative parts. |
Compatibility
This part is compatible with the following machines:
Products Compatibility
This item works with the following types of products:
- • Saw
- • Table Saw
Questions & Answers for Set Screw 10-24 X 1/4 Hex Soc
No questions have been asked yet
Repair Instructions: Submitted by Customers Like You
Tool Type:
Table Saw
Parts Used:
Repair Difficulty:
Easy
Time Spent Repairing:
More than 2 hours
Tools Used:
Screwdriver, Socket set, Wrench Set
Missing set screw, broken quick stop, and discovery of incorrectly installed SS shims were replaced or corrected.
One set screw was missing from the Miter table cam latches over the last 14 years of use by the original owner (he and I used this saw beginning in 2004 when he purchased it for a house renovation project). The second owner was my son who upgraded in 2015 after replacing the drive belts. I bought it back from my son and have used it since as a traveling construction quality saw. The parts I have bought have been to keep it serviceable as long as possible. Too many critical parts are no longer available. I will part this out unless I can find someone who has the same feeling. The Ryobi BT3000 is a good quality construction saw, used in conjunction with my 50yo Delta Cabinet saw.
1 Slide B broke, rendering the mitre table useless. It has been replaced and re adjusted.
The quick stop mitre stop broke many years ago.
What was significant and corrected was the mis installation of the SS shims that caused the Blade raise system to lock up. That required 3 total hours of investigation and correction without replacement parts, but the SS shims (Fig 59, parts 86 had to removed, hammered, and correctly reinstalled.
1 Slide B broke, rendering the mitre table useless. It has been replaced and re adjusted.
The quick stop mitre stop broke many years ago.
What was significant and corrected was the mis installation of the SS shims that caused the Blade raise system to lock up. That required 3 total hours of investigation and correction without replacement parts, but the SS shims (Fig 59, parts 86 had to removed, hammered, and correctly reinstalled.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Product Information