How to Replace the Fishtail Point on a Southland Earth Auger

The fishtail point is attached to the tip of the auger. It both centers the auger and acts as a pilot bit to guide it. Over time, the fishtail point will wear (from cutting into the abrasive soil) and it will need to be replaced.

Let's get started.

REMOVING THE FISHTAIL POINT   1. Remove the fishtail point.

a. Use adjustable pliers to loosen the fishtail point.
b. Unthread and remove the fishtail point from the auger.

INSTALLING THE NEW FISHTAIL POINT

  2. Install the fishtail point.

a. Apply a thin layer of grease to the threaded portion of the new fishtail point.
b. Thread the new fishtail point into the tip of the auger.
c. Use adjustable pliers to tighten the fishtail point.