Purge Bulb 530058709

Removed two screws on bulb retainer, removed old bulb and replaced it with the new bulb. Reattach bulb retainer and check for priming. Started blower, it works perfectly.

Take off the one 2 screws, remove old purge zama, place new part align base plate and secure with 2 screws. EASY

1. Remove the screws from the primer bulb cover and remove the old primer bulb.
2. Insert the new primer bulb in the cover and screw it to the carburetor.
3. Remove the old fuel cap and install the new one.

Removed the screws from the purge bulb retaining plate
Removed the old bulb and inserted the new bulb
Screwed the new bulb and retaining plate back on the carburetor

1. Pried and pulled off the fuel line and fuel purge line from the nipples on the trimmer. Be sure to note which line from the fuel tank goes to which nipple prior to removing them.
2. Removed 2 torx screw that hold the fuel tank to the trimmer. Disposed of the old fuel tank after removing old fuel in the tank. (The fuel was fresh so I simply poured it into the new fuel tank.)
3. Removed 2 slotted/phillips screws from the plate holding the cracked primer/purge bulb.
4. Carefully pulled off the plate and removed the cracked primer/purge bulb.
5. Carefully lifted the gasket off of the plate. Inspected the gasket for integrity and wiped clean with a lint-free cloth.
6. Wiped clean with a lint-free cloth both metal surfaces the gasket mates with to ensure a good seal when reassembling.
7. While depressing the throttle, placed gasket back in position, positioned the new primer/purge bulb in the recess, positioned the metal plate on top of the gasket with the new bulb protruding through it and firmly screwed in the 2 slotted/phillips screws. (Note: Throttle must be depressed to ensure proper alignment of all these parts which is necessary to get a good fuel seal.)
8. Attached the new fuel tank with the 2 torx screws removed earlier. Tightened screws firmly.
9. Pushed the fuel line and the fuel purge line onto the nipples as far as they would go. (Make sure the lines are attached in the exact same manner as they were with the old fuel tank.)
10. Put fuel in the fuel tank and pressed the primer/purge bulb several times until fuel fills the bulb. Checked for fuel leaks.
11. Started the trimmer per normal process. Checked for fuel leaks, again, after running the trimmer for a couple of minutes.
Overall, a very simple repair that took less than 15 minutes from start to finish. And the best part is my 7 yr old trimmer now run like it was brand new!

Removed 2 screws from the primer cover
Removed the old primer
Installed the new primer in the cover
Screwed the new primer and cover to the carburetor

Fuel line was getting hard and cracking. So replaced both fuel and purge lines. Changed the primer bulb as well. Also cleaned up the fuel screen in the carburetor.

1 Removed 2 screws
2 Removed plate holding bulb
3 Replaced new bulb in holding plate
4 Put the 2 screws back and tighten them
5 Pushed bulb pulled cord and started trimmer

Removed two screws on either side of plate used to hold bulb in place and seat bulb in groove to make air tight seal. install new bulb on first attempt bulb didn't seat properly, removed and reset bulb reinstalled mounting plate and tightened screws..success bulb maintained seal

Removed gas tank and old hoses. Removed bulb. Removed carburator. Cleaned up and installed new fuel and purge line. Installed new primer bulb. Primed carb and started trimmer.