1. Cut hole in floorboard to get to nut. (some mowers have a panel to remove)
2. Raised back end of the mower on a lift.
3. Took off the pulley with 1/2 inch socket on nut and 1/2 inch wrench on bolt. Took off pulley, belt, and hardware,
4. Put on new pulley, shoulder spacer, flange nut and belt at same time.
5.
... Read moreGround down hole in floorboard smooth. Covered with duct tape til figure out permanent cover.
6. Should have adjusted variable speed pedal while idler was apart, but didn\'t think of it at the time.
7. Later will adjust variable speed idler the long way per manual.
Read less
Did you find this story helpful?
Thank you for voting!
Gears just wore out.
stephen from Elkhart, Indiana
1 personfound this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
_WW_1.gif "Part Location Diagram of 912-0431 MTD Lawn Mower Flange Lock Nut")
_WW_1.gif "Part Location Diagram of 912-0431 MTD Lawn Mower Flange Lock Nut")
