Genuine OEM replacement part used on Bosch Demolition/Brute Hammers. This is a Metal Spring and it is Sold Individually. This Spring is attached to Tool Holder with a Microencapsulated Screw. Over time springs may loose its tension and may not function as intended. If this part is lost or damaged it must be replaced.
Keep in mind this high-quality part is made of metal and is sold individually. The indexing disk fits between the compression spring and the stop sleeve. When replacing this part a screwdriver may be needed. It will need to be replaced if it breaks. This part is an OEM sourced directly from the manufacturer for Bosch hammers.
This item is an authentic Bosch replacement part that has been sourced from the original manufacturer to be used with angle grinders. This item is used to put pressure on the brushes to keep them pressed against the armature's commutator bars. This item is available as an individual replacement part.
This spiral spring is an authentic manufacturer sourced part which is designed for Bosch routers and demolition hammers. It is an important part of the tool which applies tension on the carbon brush. Over time it may wear out and stretch eventually requiring a replacement. It is made of high-quality metal and is sold as an individual component. Refer to the diagrams for your model for the exact location and the correct installation of this hardware. You may need a screwdriver and pliers to perform this repair.
This is the brush tension spring that helps to push the carbon brush against the armature to provide a stable contact. Over time the spring may loose its tension and require a replacement. It is an authentic replacement part that is sourced directly from original equipment manufacturer. Please note this durable metal spiral spring is sold individually.
This is an original part from Bosch. The compression spring is compatible with several breaker jack hammers, and is sold individually. The metal spring is fastened to the cap screw, providing the needed resistance to the locking bolt. A hex key is required for making the replacement.
This authentic replacement part is supplied by the original equipment manufacturer and is specially designed for use with Bosch demolition hammers. The spring is utilized to apply tension on the connected part allowing it to retract. Unfortunately, over time it will wear out and it may begin to stretch eventually requiring a replacement. This high-quality component is made of durable metal and is sold individually. Make sure to refer to the appropriate diagrams for your model to ensure the proper repair procedure.
It is made of metal and is sold individually. The compression spring goes between the indexing disk and the supporting disc. A set of pliers and an allen wrench may be helpful when replacing this part. It will require replacing if it breaks or bends. This is a genuine item that is supplied by the original equipment manufacturer for use with demolition hammers, drills, and rotary hammers made by Bosch.
This is an authentic OEM part. The metal spiral spring is compatible with various power tools. The spring is often secured to the brush holder, creating the necessary balance and tension. A screwdriver may be helpful in making the proper installation. The spiral spring is sold individually.
This is an OEM part sourced directly from the manufacturer. The compression spring is designed for use in Bosch demolition hammers. This part is made of metal, and is used to apply tension to the hammer pipe. Please be aware that there are different springs used in the machine. Refer to the parts diagram to be sure of ordering the correct part. You may require a screwdriver or wrench when replacing this part. This item is sold individually.
It is a genuine OEM sourced replacement part, this component is specially produced for use with Bosch demolition hammers. The purpose of this spring is to apply tension on the striker pin, unfortunately, over time it may wear out, get damaged or simply lost eventually requiring a replacement. Keep in mind this high-quality hardware is made of durable metal and is sold individually. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this compression spring.