Product Information
Description:
This nut is made out of metal and attaches to the hand wheel assembly. It is available as an individual replacement part. It will need to be replaced if it becomes stripped or lost. This part is an OEM from Porter Cable to be used in table saws. A wrench may be needed when replacing this nut. |
Frequently Purchased With
Compatibility
This part is compatible with the following machines:
Products Compatibility
This item works with the following types of products:
- • Saw
- • Table Saw
Questions & Answers for Nut
No questions have been asked yet
Repair Instructions: Submitted by Customers Like You
Tool Type:
Table Saw
Repair Difficulty:
Easy
Time Spent Repairing:
Less than 15 minutes
Tools Used:
Socket set, Nutdriver, None
Missing parts
You had the parts I needed Very easy to find
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Tool Type:
Table Saw
Repair Difficulty:
Medium
Time Spent Repairing:
30-60 minutes
Tools Used:
Screwdriver, Socket set
Saw was bought as a floor model missing parts
All parts ordered were exactly as described. Installed all parts. All fit. Saw now runs. Thanks!
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Tool Type:
Table Saw
Repair Difficulty:
Easy
Time Spent Repairing:
15-30 minutes
Tools Used:
Screwdriver, Pliers, Adjustable Wrench
The switch and breaker were bad so they were replaced with success. The handwheel needed a replacement cap bolt
Remove the switch box from inside of the cabinet, press the tabs on top and bottom of the switch and pull out of the housing. Take the wire lead from the old switch and place them on the same terminal on the new switch. Do the same with the circuit breaker. I also replaced the lost nut on the handwheel.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Product Information