*This part replaces obsolete part #: 90051-1.
Product Information
Description:
It is a genuine item that is supplied by the original manufacturer for Sunpak infrared heaters. This is the main module that controls the ignition function. If it is faulty or stopped working at all, this should resolve the issue. Metal mounting bracket, wiring harness, and instructions are included. Make sure to refer to the owner's manual for your model for the correct application. Note, this high-quality micro module is sold as an individual item. A screwdriver will be needed to perform this repair. |
Compatibility
Products Compatibility
This item works with the following types of products:
- • Heater
Questions & Answers for New Micro Module
No questions have been asked yet
Repair Instructions: Submitted by Customers Like You
Tool Type:
Heater
Repair Difficulty:
Medium
Time Spent Repairing:
30-60 minutes
Tools Used:
Screwdriver, Pliers, Adjustable Wrench, Multimeter, wire striper
Pilot and Ignition module was not working
To Install the ignition module was easy turn of the switch 24 volts remove 2 screws from remove the old module unplug all wires connected the new one was easy replace with the new one just following the squematic wire coming with the part. Connect 24 volts 2 leads gas valve and ground.
To install the pilot also was easy remove the cover top, Remove 2 screws from the grill near control door. Pull downward at the end and the grill loose, remove hex locknut and install the new pilot and then install back all parts turn on the switch wait for three seconds and the heaters start working was so easy make work again thank you
Patricio
Handyman
To install the pilot also was easy remove the cover top, Remove 2 screws from the grill near control door. Pull downward at the end and the grill loose, remove hex locknut and install the new pilot and then install back all parts turn on the switch wait for three seconds and the heaters start working was so easy make work again thank you
Patricio
Handyman
Did you find this story helpful?
Thanks for voting and helping fellow customers!
0 of 1 people found this instruction helpful
Tool Type:
Heater
Parts Used:
Repair Difficulty:
Easy
Time Spent Repairing:
15-30 minutes
Tools Used:
Screwdriver, Nutdriver
No issues clear instructions with the part made the repair easy
Removed old part and spliced in new module per the instructions. Instructions were quite clear and easy to follow.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Product Information