Multi-Tool Parts
Search By Model or Part Number
Top-Rated Multi-Tool Parts
It is sold individually.
By pressing the bulb it will purge the air from the carburetor.
Then fuel will come up from the fuel tank through the fuel line then into the carburetor.
The excess fuel will be forced back into the tank through the fuel return line.
Over time the primer will lose its elasticity or crack and need to be replaced.
By pressing the bulb, fuel will come up from the fuel tank through the fuel line then into the carburetor.
Then the excess fuel will be forced back into the fuel tank through the fuel return line.
At some time the primer will lose its elasticity or crack and need to be replaced.
We have an article and video on How to Replace a Primer Bulb, in our Repair Center. That can be found on the front page of our site.
The Return Grommet is inserted in to the fuel tank on the outdoor products shown below.
The the Return Fuel is installed into the Grommet.
Its purpose is to create a seal and prevent fuel leaks.
It may be easier to place the return fuel line in the grommet and install both in the fuel tank at the same time.
Replacing this power supply cord you will need a screwdriver.
• Remove the housing screws
• Remove the the housing
• Disconnect the old cord wires
• Remove the old power cord
• Secure the new cord in place
• Connect the wires
• Reassemble and test the new cord
Popular Multi-Tool Models
Multi-Tool Parts by Brand
Multi-Tool Repair Articles
How to Install a Filter Kit on an Echo Trimmer (Model SRM-225) | How to Fix a 2-Cycle Engine Carburetor |
Filthy Filters? This article will show you how to install a filter kit on an Echo SRM-225... | This article will walk you step-by-step through the process of repairing a 2-Cycle... |