Manual Clutch Cable 532435111

1. Removed the two bolts holding the gas tank.
2. Removed the tension adjustment plate from the mower deck.
3. Removed the remaining clutch cable.
4. Attached both ends of the new clutch cable.
5. Replaced the tension plate, and the gas tank.
6. The replacement part was a perfect fit.

I simply started at the top and followed the broken cable down. As I removed the broken cable, I replaced it with the new one. This system worked good for me.

1. Removed gas tank.
2. Removed clutch arm spring.
3. Remove cable upper retaining holder
4. Install new cable in reverse order, getting clutch arm spring on you need three hands. Hurt my bad back, but no one complain to.
5. Then remove the mower, lower cable retaining holder, lower cable clutch spring and then install the other end of the new cable.
6 .Be very careful that you correctly route this cable to prevent the damage that was done to the used tractor I purchased. Just for your info, I am 83 1/2 yrs.

Removed the broken clutch backwards and replaced the new one. The only difficult part was engaging the bottom spring. Just a little tricky.

1. To replace the clutch cable, remove the gas tank first so it is easier to get to the cable.

2. I find it easier to replace the blades by removing the deck. It only takes about 15 min. to remove the deck, change the blades and then reinstall the deck.

Was nice to see a brief video outlining the repair. I looked at the machine I reached in and manually removed the spring on the clutch lever freeing the end of the cable. Placed new cable on and again replaced the spring with my hand. I did not have to remove the control lever and had the repair completely accomplished in about 3 minutes - counting unhooking the mower connecting spring and rerouting the cable to a more secured spot on the machine. Counting refueling time, I was mowing well within 10 minutes of starting.

Remove bolts from fuel tank, pull forward toward engine. Disconnect keeper, washer and end of cable from lever. disconnect cable from and spring from clutch break assembly after dropping and disconnecting mower deck. reroute new cable between break clutch lever and mower break clutch assembly. Reattach cable end to pin at lever, washer and safety pin.Replace fuel tank and replace hold down screws. cable replacement completed.
After drooping mower deck and removing safety pins from mower brackets slide mower deck out the left side of tractor. tilt mower deck up so you have access to bolt holding blade. hold bolt with wrench, and using a larger wrench hole upper spindle bolt. Remove lower bolt, washer, and blade. Loosed and remove upper bolt from shaft along with pulley.. remove bolts from around Mandrel assembly and remove through bottom of mower deck. Replace with new assembly is reverse of removal.Reattach deck to mower and your done.

Jack up Tractor off wheels, removed both wheels on both sides, disconnect & removed cutting assembly under tractor, removed brake clutch cable and replaced all parts & Greased wheel bracket . Removed cutting blades from assembly and replaced blades and installed it back under tractor.

1. Removed the spring from the top lever.
2. Removed the cable clamps
3. Removed the deck bracket
4. Removed the spring from the mower tensioner spot.
5. Removed the lower cable clamp from the deck bracket
5. Hooked the new cable to the Upper clutch lever pin.
6. Reconnected the upper spring
7. installed the upper cable support to the upper metal bracket
8. reconnected the cable to the body clamps
9. Reconnected the Clutch spring to the Deck pully system
10 Reattached the cable to the metal deck clamp
11. Reattached the deck clamp to the deck

Remove mower deck, remove cable, replace spring and cable replace mower deck, easy to do save yourself lots of money !!!