Cable Sleeve

This cord protector is a genuine Metabo replacement part and is sold individually.
Cord Protectors are designed to slide onto your cord and fit securely at the end, where it’s firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard.

Cord Set

This cord is a genuine Metabo replacement part and is sold individually.
This cord is made for double insulated tools
It is a two wire cord with two prongs and does not need a ground wire.
It is used on all of the Metabo tools shown below.

Switch Slide

This replacement slider switch knob is a genuine metabo part. It is supplied directly from manufacturer for use with grinders/polishers. It is the slider knob for the main on/off switch of a tool. This slider is made out of black plastic and it is sold individually.

Replacing this switch slider should only require a screwdriver.

• Make sure the tool is unplugged
• Remove the housing screws
• Remove the slider and secure the new one in place
• Reassemble and test the unit

Carbon Brush Set

This is a genuine manufacturer-supplied replacement which is specially designed for use with Metabo power tools. The purpose of a brush is to conduct the crurrent in an electric motor that powers the tool. Unfortunately, the material will wear out and it may cause intermittent performance eventually requiring a replacement. Keep in mind this high-quality brush is sold in a pack of two. When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem. Please refer to the appropriate diagrams and the owners manual for the exact location and installation of these components.

Not sure if your carbon brush is causing your motor problems? See our power tool repair article: Whodunnit? The brushes or the switch?