Main Burner For Firebox 80029717

Simply remove parts to get to burners, disconnect starter with screwdriver, remove old cotter pins with pliers, install new parts.

1. Shut off and disconnected the LP supply.
2.Removed the Grille grate and the 4 heat deflectors.
3. Removed retainer clips holding burners and cross over tubes.
4. Pulled burner tubes partially away from control valve and disconnected ignitor electrodes.
5. Removed all 4 burners tubes and 3 crossover tubes.
6. Unplugged the ignitor electrodes from the Spark module.
7. Took the opportunity to clean the inner fire box and inspect for any other signs of wear and tear.
8. Routed 4 ignitor electrodes through valve holes in firebox and plugged them on to the spark module
and snapped the other end of ignitor electrodes on to burner tubes.
9. Installed crossover tubes and clips onto burner tubes.
10. Reinstalled LP supply and checked operation.
11. Shut off grille and Reinstalled heat deflectors and grate.

1. Removed and cleaned grates.
2. Removed and cleaned infrared plates.
3. Removed heat shields.
4. Removed pins holding burners.
5. Removed burners.
6. Cleaned around inside firebox.
7. Put in new burners.
8. Put in new pins.
9. Turned on propane and tested.
10. Everything worked great.

Parts fit as direct replacements, just remove old parts and clean grill while parts are out of the way, reassemble with the new parts. My grill works like new again was real easy.

1 Removed all rusted parts to be replaced and cleaned fire box with Shop Vac. This was done prior to placing order which helped me determine exactly what I needed. Approximately 30min.

2 When I received the parts I started with the main burner tubes following the instructions included each tube was inserted and a cotter pin placed on the back end of each tube secured them. Needle Nose pliers made this easy.

3 The carry over tube assembly was next but before you can complete this part you need to screw a small eyelet screw in the front of each burner tube. When this is completed the carry over tubes can be put in place and secured with a cotter pin.

4 The final step was to place the 4 heat tents over each burner. They simply fit into a niche in the fire box over each burner. Approximately 30 min.

Removed the grill grates and cleaned them
Removed the heat emitters and tossed them
Removed the flame tamers and cleaned them
Unplugged the burner electrodes and removed the rusted out burner tubes
Completely cleaned out the main box
Attached the new igniters to the new tubes and replaced the tubes
Ran the wires to the new ignition module and attached them
Attached the flame carryover tubes
Started the grill, testing each burner
Reset the flame tamers, heat emitters, and grill grates

This was a very simple repair.
Remove old rusted parts.
Minor clean up of the burner area.
Install replacement parts.
Everything fit in place correctly without modification.
Test for proper operation - good to go!

Took all the grates off grill, then removed the burners and cross over lighter. Not to difficult cause of rust and decay. New parts worked great as they were charbroil grill parts. Bad thing is I saw other repairs that will be needed to be addressed. Everything went smoothly and parts were shipped as promised.

Very happy with this product. Saved hundreds of dollars by not having to replace our grill.

1. Remove the grill grates.
2. Remove the old heat tents.
3. Remove the cotter pins from the carryover tube assemblies.
4. Remover the cotter pins from the gas tubes.
5. Replace in the reverse order.