Lawn Mower Wing Knob 720-05066A

The upper handle broke on one side just above the bolts that attached it to the lower handle and I had lost a nut and wing knob that holds the handle in place on the case. Completed the following steps:

1. Cut the wire tie holding the throttle safety cable
2. Removed the bolts in the handle
3. Removed the broken handle
4. Removed the throttle safety handle
5. Removed the starter pull cord
6. Attached the starter pull cord to the new handle
7. Attached the throttle safety handle to the new handle
8. Attached the new handle with the bolts
9. Replaced the new wire tire on the handle to hold the throttle safety cable
10. Replaced the lost nut and wing knob to the base of the handle on the mower case

Just needed to screw in the wing knob bolt where it belonged. Very easy

Wing nut bolt was the exact replacement part needed, didn't realize until I went to put it on that
the nut was also missing from its place on the mower. I had nothing to screw wing bolt too.
Hoping that Lowes has the square nut.

Hello. Instead of going to the local home improvement centers or shops try to fit or find oem parts. This is the place to get oem parts that makes any repairs easy. Thank you😁

Pulled the mower handle into the proper position and installed the 2 replacement bolts.

Screwed in both screws to hold the handle in place. Design these with nuts would make them safer over time.

Easy peasy...my model wasn't even listed for these parts, but they looked the same, and they were identical for a Yard-man 625 series push mower (2011).