Large Axle Cover 286660

Removed the locking allen screw from post
Slid old sleeve assembly off
Removed good inside bearing and put into new sleeve
Put new outside bearing into sleeve
Slid new assembly back onto post with new cover on outside
Put screw back on and tightened

1. Removed both axle covers
2. Unhooked the arms from the pedal arm sleeves
3. Removed the sleeves
4. Pushed out the bearings on each side and placed them in the new sleeves
5. Used Teflon lube on both sides
6. Slid sleeves back on
7. Replaced axle covers on both sides
I only used a screwdriver, a rag, and some lubricant to do the job. Had a workout on the repaired machine and it worked great!

Replaced broken cap with new one

Unscrewed old part screwed on new

Took off existing bad parts in order. Laid out the new parts and put them back on in reverse order. Took less than 15 minutes

1. Use Allen wrench to remove the bolt holding the broken axle sleeve and cover.
2. Use a screwdriver to push out bearings from the old axle sleeve. You may be able just to use a finger to pull them out.
3. Put the usable original bearings in new axle sleeve then put on the axle.
4. Place large axle cover over axle sleeve and secure it with the Allen bolt and wrench.
5. Repeat for other side.

1. Removed screw holding cap.
2. Removed sleeve.
3. Tapped bearings our of old sleeve.
4. Inserted bearings into new sleeve.
5. Put sleeve back on shaft.
6 Installed new cap.

Key point to note: Ordered parts on line on July 4. Order was filled that day and shipped the next day. Received parts several days later. Got status emails every step of the process. Couldn't have been better!

1. Removed old broken parts with an allen wrench
2. Replaced with new eReplacement parts.

1. Removed screw, broken cover and sleeve
2. Replaced with new sleeve and cover
3. Screwed the screw and washer back in
4. Also replaced the axle cover
ALL DONE!

Remove pedal arm from arm sleeve. Used Allen head wrench to remove the bolt holding the axle cover and pedal arm sleeve on the axle arm. Slide pedal arm sleeve from axle arm, careful not to damage bearings on the axle sleeve. Use a screw driver to Carefully remove bearings from axle sleeve and inspect them to make sure they are in good working order. If the bearings are not in good condition, order new replacements before completing the repairs. Insert bearings in the new are sleeve the same way they were removed. Slide pedal arm sleeve onto axle arm, place axle cover onto the end of the axle sleeve and secure in place with bolt and washer. Clean any debris from the underside of the pedal arm then Re align pedal arm and secure in place.