*This part replaces obsolete part #: 224265-2.
Product Information
Description:
It is a genuine OEM supplied replacement part that is specially produced for Makita saws. The purpose of this flange is to helps securing the saw blade to the shaft. This part is made from high quality metal and it is sold individually, please note the outer flange and the blade bolt are both sold separately. |
Frequently Purchased With
Products Compatibility
This item works with the following types of products:
- • Circular Saw
- • Generator
- • Saw
Questions & Answers for Inner Flange 40
No questions have been asked yet
Repair Instructions: Submitted by Customers Like You
Tool Type:
Circular Saw
Parts Used:
Repair Difficulty:
Easy
Time Spent Repairing:
Less than 15 minutes
Tools Used:
Adjustable Wrench
Lost part
Lost washer during a blade replacement.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Tool Type:
Circular Saw
Repair Difficulty:
Easy
Time Spent Repairing:
Less than 15 minutes
Tools Used:
Screwdriver
Blade guard lever broken and missing inner flange
Replaced lever and flange
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Tool Type:
Circular Saw
Parts Used:
Repair Difficulty:
Easy
Time Spent Repairing:
Less than 15 minutes
Tools Used:
Adjustable Wrench
Missing the inner flange for the saw blade.
Replaced with a new inner flange.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
0 of 1 people found this instruction helpful
Tool Type:
Circular Saw
Repair Difficulty:
Easy
Time Spent Repairing:
15-30 minutes
Tools Used:
Screwdriver, Hex
Lost Inner Flange Working in Woods, Needed a Hook Assembly (Didn't come new with one)
Just added the necessary components to the saw. Hook assembly has been very nice to have.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
0 of 1 people found this instruction helpful
Tool Type:
Circular Saw
Parts Used:
Repair Difficulty:
Easy
Time Spent Repairing:
15-30 minutes
Tools Used:
Screwdriver, wire crimpers
Repaired power cord, brushes and replaced flange nuts
Removed half of the switch handle, Remove two screws from cord holder, removed the the cord wires from the switch, cut the cord leads to the correct length, had to locate two terminals to put on the end of the cord leads. Attached cord leads to switch.don't for get to put the old cord relief back onto the new cord. reattached the cord holder with the two screws. Then replace the handle half. For the brush set, I removed the brush caps, then removed the old brush set and installed the new set and the brush caps. I also replaced the inner and outer flanges, and the blade bolt.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Product Information