Idle Gear D 10NXK
Part Number: 10NXK
Ships within 1 business day
*This part replaces obsolete part #: TGT0541.
Product Information
Description:
| It is a genuine Shimano component which is specially designed for use with fishing reels. The gear is an important part of the unit which helps to drive the shaft. Unfortunately, over time it may wear out or get damaged eventually requiring a replacement to ensure your reel functions properly. One durable plastic idle gear is included. Refer to the appropriate diagram for your model for the correct application. You will need a screwdriver to take the reel apart in order to perform this repair. |
Frequently Purchased With
Compatibility
This part is compatible with the following machines:
the 16 compatible machines
Products Compatibility
This item works with the following types of products:
- • Reel
Questions & Answers for Idle Gear D
No questions have been asked yet
Repair Instructions: Submitted by Customers Like You
Tool Type:
Reel
Parts Used:
Repair Difficulty:
Easy
Time Spent Repairing:
15-30 minutes
Tools Used:
Screwdriver
Nylon level wind gear on fishing reel broke.
1. Removed four screws from reel cover on non-handle side of reel.
2. Removed cover to expose nylon gear.
3. Removed screw holding gear in place.
4. Removed broken gear, put new gear in place.
5. Secured new gear with screw.
6. Replaced reel cover, secured four screws to hold cover in place.
7. Gone fishing!!
2. Removed cover to expose nylon gear.
3. Removed screw holding gear in place.
4. Removed broken gear, put new gear in place.
5. Secured new gear with screw.
6. Replaced reel cover, secured four screws to hold cover in place.
7. Gone fishing!!
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Tool Type:
Reel
Repair Difficulty:
Easy
Time Spent Repairing:
Less than 15 minutes
Tools Used:
Screwdriver, Pliers, Wrench Set
The Line Leveler was not functioning correctly and the reel handle was not smooth and would get stuck
1. Remove the end plate on the end of the Line counter (Opposing end of handle)
2. Locate idle gears that operate the line level.
3. Verify that they teeth on the gears were bad (Flat or missing)
4. Using needle nose pliers remove the gear
5. Lubricate the new gear with lithium grease and then replace.
6. Replace steps with the second gear
2. Locate idle gears that operate the line level.
3. Verify that they teeth on the gears were bad (Flat or missing)
4. Using needle nose pliers remove the gear
5. Lubricate the new gear with lithium grease and then replace.
6. Replace steps with the second gear
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Product Information
