This Genuine Manufacturer Sourced replacement part is designed to work with Carpet Cleaners/Steamers. This Foam Extractor Filter-Float is Sold Individually.

It provides filtration for the dirty water entering Vacuum. Your carpet cleaner is equipped with a shut off valve within your dirty water tank. When the dirty water tank becomes full, the blue float will rise, shutting off the air flow thru the nozzle.

No special tools are required for replacement.

• Grasp handle and pull tank out of base
• Remove Dirty Water Tank Lid
• Remove Old Filter
• Rinse dirty water tank
• Place the new filter in place
• Re-Attach Dirty Water Tank back to the unit

This is a genuine OEM approved replacement brush block designed for use with Hoover cleaners. It spins to pick up the dust and dirt from the carpet. This part is made out of plastic and it is sold individually.

When replacing this part you would need a screwdriver.

• Remove screws securing the brush
• Remove belt from the roller
• Remove old brush block and snap the new one in place
• Connect belt to the spindle
• Secure brush block with screws

This is a Genuine OEM sourced replacement part designed for use with Hoover Steam Vacuums. This item is made out of Plastic and it is Sold Individually.

To replace this item you would only need Pliers.

• From the center position you want to turn the latch and pull it straight up
• Then use the pliers to squeeze the split side and slide the new latch down

Genuine Manufacturer Approved replacement part used on some Hoover Vacuums. This is the Rubber Seal for the Solution Tank which keeps the solution inside the tank. This part is made out of Plastic and Rubber and it is Sold Individually.

This is a genuine Hoover replacement part designed for use with SteamVac cleaners. This is a dark blue plastic handle used on the clean solution tank. It is made to fold out of the way when not in use, and to fold up for carrying. It is easily replaced using no tools; just snap into place.

Genuine OEM Hoover replacement part, this item is sold individually. This part is connected to the Brush Block to rotate the brushes in certain Hoover Vacuums. This kit includes the Pin and the Screw.