Spring Washer

This is a pack of 10 washers which are genuine OEM replacement parts. They are used in many different tools made by Hitachi. These washers are designed to make sure that the nut does not come unscrewed from the device. Please refer to the specific owner's manual of your tool model to ensure proper installation. This package contains 10 washers.

Ball Bearing

Genuine Manufacturer Sourced replacement part used on Hitachi Power Tools. This part is made out of Metal and it is sold individually. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear on the tool and allows it to run smoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

Punch

It is a genuine item that is supplied by the original equipment manufacturer for use with Hitachi nibblers. The punch is an important component that helps to drive the piston. This item provides an identical replacement for a faulty or a missing part that was installed on a new unit. Please make sure to refer to the appropriate diagrams of your model for the exact location and the correct application of this part. It is made of durable metal and is sold individually. To perform this repair you will need a screwdriver and a wrench set to take the tool apart.

Carbon Brush Set

Set of 2 Carbon Brushes with wire leads and brush springs attached. The set contains genuine Hitachi replacement parts, and comes packaged in a Hitachi retail box.This brush set will fit the Hitachi tools listed at the bottom of the page.

• Worn brushes frequently are the cause behind a motor running poorly.
• Replacing brushes can fix a motor that’s operating intermittently.
• New brushes can restore a motor’s electric braking.

Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.