Hex. Flange Head Bolt M8x20 265315-4
Part Number: 265315-4
Ships within 1 business day
Product Information
Description:
| Authentic replacement part designed for use with circular saws. It helps to secure the saw blade. This genuine Makita hex head bolt is a reverse threaded bolt which is sold individually. When installing or removing it you would need to use a wrench. |
Frequently Purchased With
Compatibility
Products Compatibility
This item works with the following types of products:
- • Circular Saw
- • Saw
Questions & Answers for Hex. Flange Head Bolt M8x20
No questions have been asked yet
Repair Instructions: Submitted by Customers Like You
3 of 3 people found this instruction helpful
Tool Type:
Circular Saw
Parts Used:
Repair Difficulty:
Easy
Time Spent Repairing:
Less than 15 minutes
Tools Used:
Socket set
Left hand thread bolt to secure blade on Makita hypoid saw
Remove old bolt, install new one.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Tool Type:
Circular Saw
Parts Used:
Repair Difficulty:
Easy
Time Spent Repairing:
Less than 15 minutes
Tools Used:
Screwdriver, Wrench Set
Flange bolt broke
Extracted the broken part of the bolt out of the saw, and then put the new left handed thread bolt and blade ba back on the saw and tightened it up.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Tool Type:
Circular Saw
Parts Used:
Repair Difficulty:
Easy
Time Spent Repairing:
Less than 15 minutes
Tools Used:
Wrench Set
Hex nut broke
Took the bolt out and put new one in
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Tool Type:
Circular Saw
Parts Used:
Repair Difficulty:
Easy
Time Spent Repairing:
15-30 minutes
Tools Used:
Screwdriver, Pliers
Power cord wires broke.
1. Remove screws.
2. loosen retaining bracket.
3. loosen screws for wires.
4. Modify wire to place under screw.
2. loosen retaining bracket.
3. loosen screws for wires.
4. Modify wire to place under screw.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Tool Type:
Circular Saw
Parts Used:
Repair Difficulty:
Easy
Time Spent Repairing:
15-30 minutes
Tools Used:
Screwdriver, wire crimpers
Repaired power cord, brushes and replaced flange nuts
Removed half of the switch handle, Remove two screws from cord holder, removed the the cord wires from the switch, cut the cord leads to the correct length, had to locate two terminals to put on the end of the cord leads. Attached cord leads to switch.don't for get to put the old cord relief back onto the new cord. reattached the cord holder with the two screws. Then replace the handle half. For the brush set, I removed the brush caps, then removed the old brush set and installed the new set and the brush caps. I also replaced the inner and outer flanges, and the blade bolt.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Product Information
