Hammer Drill Parts
Search By Model Number
This brush set will fit the Makita tools listed at the bottom of the page.
• Worn brushes frequently are the cause behind a motor running poorly.
• Replacing brushes can fix a motor that’s operating intermittently.
• New brushes can restore a motor’s electric braking.
Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.
Replacing this power supply cord you will need a screwdriver.
• Remove the housing screws
• Remove the the housing
• Disconnect the old cord wires
• Remove the old power cord
• Secure the new cord in place
• Connect the wires
• Reassemble and test the new cord
Cord Protectors are designed to slide onto your cord and fit securely at the end, where it’s firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard.
This screw is commonly found in Dewalt cordless drills and it is compatible with the tools listed below. It is not guaranteed to fit any other power tools.
Browse Hammer Drill Parts
Hammer Drill Repair Videos
Hammer Drill Repair Articles
|How to Replace the Carbon Motor Brushes on a DeWALT Drill||How to Diagnose a Bad Power Cord or Switch|
|Drill losing power? Learn to quickly remove and replace the motor brushes and holders on your DeWALT drill. Simple...||This article outlines the basics of power tool and appliance electrical diagnosis. You can use a multimeter to test...|