Product Information
Description:
The hammer case cover attaches to the bumper and to the hammer case. This item is made of plastic and is priced as an individual replacement part. This genuine item is supplied by the original equipment manufacturer for use with Makita impact drivers. A screwdriver and a set of pliers might be helpful during the installation of this part. It may become broken and will need to be replaced. |
Frequently Purchased With
Compatibility
the 21 compatible machines
This part is compatible with the following machines:
Makita
LXDT04 18V LXT Lithium-Ion Cordless Impact Driver Kit
LXDT04CW Cordless Impact Driver
BTD146 Drill / Driver
LXDT03 (Type 1) Drill / Driver
LXDT03 (Type 2) Drill / Driver
LXDT03 (Type 3) Drill / Driver
LXDT03Z (Type 1) Drill / Driver
LXDT03Z (Type 2) Drill / Driver
LXDT03Z (Type 3) Drill / Driver
LXDT04C1 (Type 1) Drill / Driver
LXDT04C1 (Type 2) Drill / Driver
LXDT04CW Cordless Impact Driver
BTD146 Drill / Driver
LXDT03 (Type 1) Drill / Driver
LXDT03 (Type 2) Drill / Driver
LXDT03 (Type 3) Drill / Driver
LXDT03Z (Type 1) Drill / Driver
LXDT03Z (Type 2) Drill / Driver
LXDT03Z (Type 3) Drill / Driver
LXDT04C1 (Type 1) Drill / Driver
LXDT04C1 (Type 2) Drill / Driver
Products Compatibility
This item works with the following types of products:
- • Impact Driver
Questions & Answers for Hammer Case Cover
No questions have been asked yet
Repair Instructions: Submitted by Customers Like You
Tool Type:
Impact Driver
Parts Used:
Repair Difficulty:
Easy
Time Spent Repairing:
Less than 15 minutes
Tools Used:
Screwdriver, Vise grips
The hammer case was broken and the hammer case complete had scratches and dents the ring spring was missed place and the bit sleeve was wobbly
I removed the bit sleeve with the washer, spring and the silver balls.
Loosened the hammer cover, removed the gear assembly, removed the anvil and before I decided to put everything together with the new parts I Re-greased the gears and the inside of the new hammer case complete. Than I went ahead and re assembled everything.
Loosened the hammer cover, removed the gear assembly, removed the anvil and before I decided to put everything together with the new parts I Re-greased the gears and the inside of the new hammer case complete. Than I went ahead and re assembled everything.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Tool Type:
Impact Driver
Parts Used:
Repair Difficulty:
Medium
Time Spent Repairing:
15-30 minutes
Tools Used:
Screwdriver, Pliers
Drill would hesitate
Take off back cover. remove all screws, take a picture of the switch to make sure you have the correct wires going to the proper terminals. Remove old switch and install new one in reverse order. While I was in there I replace the worn F/R Change Lever. Also replace missing bumper and cracked hammer case cover, they just snap on.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Product Information