Product Information
Products Compatibility
This item works with the following types of products:
- • Saw
- • Table Saw
Questions & Answers for Gear Housing
No questions have been asked yet
Repair Instructions: Submitted by Customers Like You
Tool Type:
Table Saw
Parts Used:
Repair Difficulty:
Medium
Time Spent Repairing:
1-2 hours
Tools Used:
Screwdriver, punch to remove pins in shaft holding gears
Difficult to raise and lower blade
With saw upside down, remove motor (4 screws) (tilt saw to approx. 45 degrees), remove screws holding guide rods and screw shaft, remove guides and shaft. replaced gears on shaft while off saw, (they looked ok), remove screws on gearbox, remove gear box, install old gear box in new housing (put some grease in gearbox and housing)New housing had small needle bearing already pressed in even though I bought a new one, didn't say it came with bearing , reinstall guide rods and screw shaft, reinstall motor ( remove brushes first) reinstall misc covers , done. Works great now!
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Product Information