Fuel Line 6688169

0. Remove the remaining fuel from the tank. Using a funnel I put the fuel back into my 1 gallon gas can.
1. Removed the air cleaner cover.
2. Removed the hardware holding the tank in place.
3. Disconnect the fuel lines at the carburetor and primer, paying close attention to which line goes where.
4. Installed the new vent, return line and fuel line and filter into the new tank.
5. Removed the old primer and installed the new one.
6. Attached the new fuel lines to the correct places on the primer and carburetor.
7. Placed the new tank into position using the mounting bracket and screws attached the tank to the engine.
8. Filled the tank with fuel.
At this point I tried to start the saw, it would not start. I found that I had flooded the carburetor when I was checking the operation of the new primer.(guess I primed it one to many times!) Removed the spark plug then, using compressed air I dried the inside of the cylinder and the spark plug, reassembled and started the saw.
9. Installed the new air cleaner I had purchased and reinstalled the air cleaner cover.
10. Put the saw back to work trimming trees.

Made a hook out of some wire and fished the fuel filter out of the tank and removed it from the fuel line. Remove the old fuel line from the carburetor and tank. Put some oil on the fuel line grommet and pressed it in the fuel tank and fished out enough line to place the filter on the fuel line with the clip.

Used needle nose pliers to remove the old parts and replaced with the new ones.

Removed carburetor to a access fuel lines & primer pump, used wire with hook to remove the fuel filter. I replaced the fuel line fuel filter & primer pump. Then I dissembled the carburetor cleaned it in my ultrasonic cleaner resembled, reinstalled, checked the compression 110 lb. cranked it up it ran fine, oiled the blade.

Removed the filter, pulled the fuel line and replaced

remove carburator and protective cover. remove all plastic lines and changed them including fuel filter. Had problems with the new plastic fuel lines being that my machine is older and the new fuel line is larger. Had to drill out the line hole in the fuel tank for better fitting.

1. Removed filter cover
2. Removed old filter
3. Removed filter assembly.
4. Removed old fuel line.
5. Replaced fuel line.
6. Reassembled filter assembly
7. Replaced filter.
8. Attached cover

I removed the leaking fuel tube and replaced it with the new one

Replaced items.

unscrewed switch changed out contacts A and B. Could not fix spark plug issue without spring. Fuel line was easy with handmade wire hook