eReplacementParts.com
877-346-4814
Bissell Parts
Repair Parts Home  Vacuum Parts  Bissell Parts  B-203-6655 Crevice Tool

Install
Videos!
Grid squares measure 1x1 inch
Crevice Tool - B-203-6655:BissellCrevice Tool - B-203-6655:BissellCrevice Tool - B-203-6655:Bissell

Crevice Tool B-203-6655

Part Number: B-203-6655
Bissell
Availability: In Stock
Price: $16.52
Order within the next 29 minutes
and your part ships today!

*This part replaces obsolete part #: B-210-9148 and B-010-9148.

Product Information
Description:
This is a genuine Bissell replacement part manufactured for use with carpet cleaners. The plastic crevice tool is an attachment used for cleaning hard to reach areas. This crevice tool is compatible with several types of carpet cleaners, no tools are required to install the crevice tool. The crevice tool is sold individually.
Compatibility

This part is compatible with the following machines:

Bissell
Expand the 64 compatible machines
Products Compatibility

This item works with the following types of products:

  • • Deep Fryer
  • • Vacuum

Questions & Answers for Crevice Tool


No questions have been asked yet
Repair Instructions: Submitted by Customers Like You
0 of 1 people found this instruction helpful
Tool Type:
Vacuum
Parts Used:
Crevice Tool - B-203-6655
Water Tank Cap Assembly - B-203-6675
Autoload Receiver - B-203-6758
Gasket-short Air Duct Upper - B-203-6693
Gasket-short Air Duct-lower - B-203-6815
Tank Assembly - Red Berends - B-203-6961
Autoload Gasket - B-203-6679
Repair Difficulty:
Easy
Time Spent Repairing:
15-30 minutes
Tools Used:
Screwdriver, Silicon faucet grease
Would not pick up dirty water from cleaned area.
Initial problem was would not pick up water after cleaning from carpet. Tested at vacuum motor, had good suction there, diagnosed problem to dried out seals on pick-up side. Replaced seals to correct problems.
1) Dis-assembled to locate seals needed.
2) Re-assembled right away with old original parts.
3) Ordered parts needed.
On arrival of parts.
4) Inspect parts and sorted order needed to go in starting at base up.
5) Dis- assembled replacing parts one for one, like for like.
6) To optimize good sealant used silicon faucet grease on seals light coat only. (It is light and water resistant). Aids in assembly lubrication.
6) Tested good.
Note: Correct installation per mfg. directions is important. Top vacuum chamber drops in front and hooks in the bottom front dropping down in the rear into the upper duct assembly. Soap dispenser must be in place.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Product Information
eReplacementParts.com
7174 South 400 West
Suite 5
Midvale, UT 84047
visa mastercard discover american express PayPal