Auger control is stuck on. It appears that this clutch lock spring may be bent. I removed the screw holding it in place and attempted to figure out the correct placement of the widest part of the spring in relation to the auger control and the locking mechanism which is engaged by the drive control. Before removing it looked as thought the locking mechanism would slide over the bottom of the spring, but now that it's removed, it doesn't appear as though it can fit between the auger control and the locking mechanism. I'm unable to find either a schematic or an image which shows the clutch lock spring in its proper placement. Any assistance in finding an image/schematic or instruction for replacement is greatly appreciated.