Search By Model Number
This is a genuine Husqvarna fuel line that is commonly used on gas trimmers and blowers. It is supplied directly from original equipment manufacturer. The fuel line delivers gasoline from the tank into the carburetor. These fuel lines are made out of clear flexible rubber material that over time may begin deteriorate and crack allowing for leaks. At this point it is time to replace the line. Includes one 25-inch fuel line.
The purpose of the 530069216 Tank Purge Line is to return the excess fuel that is in the carburetor after the primer bulb has been pushed.
The excess fuel is forced through the purge line back into the fuel tank.
Over time the Tank Purge Line will become brittle and crack and will need to be replaced.
This is an OEM part sourced directly from the manufacturer. The fuel filter helps to take out all the impurities and debris that could be harmful to the carburetor. This filter is most commonly used in trimmers, shredders, blowers, edgers and chainsaws. The compatible models are listed below. This part is made out of metal and a felt type material. This fuel filter is sold individually. To install this filter you will slide it onto the fuel line, then use a screw diver to position the clamp firmly over the nipple.
This is a genuine OEM replacement part, it is sold individually.
The Fuel Filter is inside of the fuel tank.
Its purpose is to filter out dirt and other debris from contaminating the carburetor.
It will at sometime become clogged and restrict the fuel getting to the carburetor,and will have to be replaced.
We do have an article and video on How to Replace the Fuel Filters in Your Outdoor Power Equipment..
You can see this by going to the front page of our site and clicking on Repair Center.
Genuine Makita replacement part
Includes two Carbon Brushes with wire lead attached.
• Worn brushes frequently are the cause behind a motor running poorly.
• Replacing brushes can fix a motor that’s operating intermittently.
• New brushes can restore a motor’s electric braking.
Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.
Browse Chainsaw Parts
Chainsaw Repair Videos
Chainsaw Repair Articles
|How to Install a Filter Kit on an Echo Trimmer (Model SRM-225)||How to Fix a 2-Cycle Engine Carburetor|
|Filthy Filters? This article will show you how to install a filter kit on an Echo SRM-225...||This article will walk you step-by-step through the process of repairing a 2-Cycle...|