Catch Pan Kit 93305

Put new tray into holder. Two seconds.!!!!!!!!!!!!!!

Remove all gratings, flavorizer bars, bottom pan and drip pan. Clean those and set aside. Clean inside the main body of the grill, especially around the 3 hex head / standard slotted screws holding in burner bars. Hit those with penetrating oil and let soak a little while. If you can get them out with a nut driver congratulations. I had to use vice grips on 2 of them. Remove the igniter ceramic from the front left burner tube by pull towards igniter button. Unscrew the igniter push button top. Compress the plastic tabs that hold the control unit in place and lower from hole.
Gently lift the left end of the burner tube and work them off the gas distribution manifold under the control knobs. Insert the middle burn bar and work onto manifold. Do not fasten yet. Repeat on rear bar. Insert cross over tube in hole on rear tube. Place front burner bar through hole to manifold and insert cross over tube in hole on other end. Gently work the tube into manifold and don't pull cross over tube out of either burner tube. Once all tubes are back in place, secure with the 3 screws on the left ends. Note that the hardware that comes with the tubes is for the manifold end and I did not use these. I wish the tubes came with these 3 screws. Slide the igniter into the ears on the front burner tube until it stops. Secure wire with the plastic clips to the manifold. Push new igniter control box into position until tabs lock, then connect the wires from the igniter. Install the AAA battery (not that it only works when battery is installed correctly). Screw on button. Reinstall the bottom pans, flavorizer bars and grates.

Removed old pan and replaced with new one

1. Removed tray
2. Removed remains of catch pan holder
3. Installed new catch pan holder and catch pan kit
4. Installed tray.

Remove and replace

Replaced the rusted parts

Removed old parts
Installed new parts

Followed the included directions. Very easy and straightforward.

Followed instructions

Replaced all internal parts as well as warming rack. Very easy repair.