Caster With Insert 99241

The hardest thing was to lift the grill up. Needed an extra pair of hands. Once you have the grill the way you want it. Remove the old insert, then tap the new one in, then press the new caster in with your hand.

1. Removed old casters with pliers and hand pressure down.
2. Inserted new caster stems into existing inserts. (did not use new inserts)
3. Finished!

Bought my Weber Genesis Gold C grill in 2004. It was time to rebuild it.
eReplacements managed to have everything I needed.
The new Side Burner Base and Electrode were super easy to put together and install.
The only tricky part of the side burner is being very careful with the fragile Rigid Tube that connects from the gas manifold to the side burner base.
The best way to both remove and reinstall this rigid tube is to use either an open end wrench, or adjustable wrench...Do not attempt to do this with a set of pliers. This tube is very thin walled, and you stand a chance of breaking this tube.

The Control Panel was just as easy to install. The trick to this is to install the Control Panel before you install the side burner section. If you do this, you won't have any issues installing this.

The Casters w/inserts are the easiest to install. Simply tap the caster receivers into each leg opening, and push each caster into it's receiver.

I love the fact the eReplacements has everything I would need to keep my Weber grill operating at its peak performance.
Their prices are very competitive, and shipping is very fast with everything I ordered very well packaged. Very pleased.

Used a flathead to start to loosen them then popped them out, put the new one in and was done in five minutes

Tilted up grill and blocked it, tapped out old wheels then tapped out old inserts with flat blade screwdriver and hammer.
Installed new inserts and casters. Grill moves around the deck like a sports car now!

Tilted grill and propped right side up enough to remove caster w/insert. Placed new insert in slot and lightly tapped into place with a small block of wood and hammer until it was seated. Completed other side in same manner. Caster w/insert was an exact fit and was very easy to replace.

1. Popped the old caster off and inserted the new one. The leg inserts were the same, and plastic, so I did not have to replace those.
2. Product was an exact match for my older model Genesis.

1. tipped up the grill and pulled off the old caster inserts and then popped the new ones in. Total time about 1 minute per wheel! Smooth as silk.

Raised one end of the grill at a time using a 2x4 as a lever, and placed a block under the grill end, then removed the old (caster) wheel with a screwdriver and hammer, then removed the caster insert from the leg frame with a large screwdriver and hammer. Then inserted the new caster insert and tapped the wheel (caster) into the insert.

Pried off old casters with a screwdriver and replaced with new.