Product Information
Description:
This is an authentic replacement part manufactured for use with gas powered trimmers. The carburetor gasket is used to form a seal between the carburetor and the head dam. It is recommended to replace gaskets when servicing carburetors. This gasket is sold as an individual replacement part, please see model diagram for associative parts. |
Compatibility
This part is compatible with the following machines:
Products Compatibility
This item works with the following types of products:
- • Trimmer
Questions & Answers for Carburetor Gasket
No questions have been asked yet
Repair Instructions: Submitted by Customers Like You
Tool Type:
Trimmer
Repair Difficulty:
Easy
Time Spent Repairing:
30-60 minutes
Tools Used:
Screwdriver, Socket set
Would not yum at high speed
Very simple removed old carb installed new onr
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Tool Type:
Edger
Repair Difficulty:
Easy
Time Spent Repairing:
15-30 minutes
Tools Used:
Screwdriver, Spark plug wrench
Unit would not run
1. Replaced carburetor
2. Replaced carburetor gasket
3. Replaced spark plug
4. Unit would not run, was getting no gas. After blowing in the fuel tubes, the feeder tube was plugged.( Should have done this first )
5. Removed the fuel tank, found the restrictor/filter corroded and plugged. Disassembled the restrictor, used safety wire to clear the passageway cleaned everything reassembled. Unit ran fine. ( There was no mention of this problem in the comments )
6. Adjusted the idle a little. Amazing!
7. The parts were not needed but, I left them on anyway.
2. Replaced carburetor gasket
3. Replaced spark plug
4. Unit would not run, was getting no gas. After blowing in the fuel tubes, the feeder tube was plugged.( Should have done this first )
5. Removed the fuel tank, found the restrictor/filter corroded and plugged. Disassembled the restrictor, used safety wire to clear the passageway cleaned everything reassembled. Unit ran fine. ( There was no mention of this problem in the comments )
6. Adjusted the idle a little. Amazing!
7. The parts were not needed but, I left them on anyway.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Product Information