Carbon Brush Set CB325
and your part ships today!
*This part replaces obsolete part #: 194074-2.
Genuine Makita replacement part. Set of 2 Carbon Brushes with wire lead attached. • Worn brushes are often the cause of a poorly running motor
|
This part is compatible with the following machines:
9557NB Angle Grinder
9557PB Angle Grinder
9554NB Angle Grinder
9553NB Angle Grinder
GD0600 Paddle Switch Die Grinder
HR2811F 1-1/8" LED Light Rotary Hammer
HR2470F 15/16" LED Light Rotary Hammer
BHR202 18V LXT Lithium-Ion Cordless 7/8" SDS-Plus Rotary Hammer
GD0601 1/4" Die Grinder
9553B Grinder
9553NBK Grinder
9554NBK Grinder
9555NB Grinder
9555NBK Grinder
9557NB2 Grinder
9557PBX1 Grinder
9558HN Grinder
9564P Grinder
GA5040 Grinder
GA5040X1 Grinder
HR2230 Drill
HR2470FT (Type 1) Misc
HR2470FT (Type 2) Misc
HR2600 Misc
HR2601 Misc
HR2610 Misc
HR2611FT (Type 1) Misc
HR2611FT (Type 2) Misc
HR2611F (Type 1) Misc
HR2611F (Type 2) Misc
HR2631F Drill
HR2651 Misc
HR2811FT (Type 1) Misc
HR2811FT (Type 2) Misc
HR2811FX Misc
This item works with the following types of products:
- • Grinder
- • Rotary Hammer
Brushes Worn Out? Learn to remove and install the carbon motor brushes on your Makita grinder. Step-by-step instructions...
November 24, 2015
|
Questions & Answers for Carbon Brush Set
2. Disassemble all screws to remove cover and output gear assembly.
3. With needle nose pliers carefully remove carbon brush set slip on connector. Place pressure spring to one side allowing removal of brush.
4. Pull armature out. If rubber retaining gasket remains in unit and doesn't come out with the armature and attached to the bearing, take a gasket hook removal tool and remove the grommet being careful not to damage it.
5. Place the grommet on the end bearing.
6. Insert the armature assembly with grommet into the grinder body placing the grommet into the socket inside the grinder body.
7. Attached carbon bushings into their respective positions.
8. Place pressure springs back into their correct original positions.
9. Reassemble grinder body in the reverse sequence.
10. Plug grinder in. Turn on and test.
2. Put new in
- 1
- 2
- 1
- 2
Brushes Worn Out? Learn to remove and install the carbon motor brushes on your Makita grinder. Step-by-step instructions...
November 24, 2015
|