Carbon Brush Set 2610007957
and your part ships today!
*This part replaces obsolete part #: 3604321514.
Genuine Bosch replacement part Set of 2 Carbon Brushes with wire lead attached. • Worn brushes are often the cause of a poorly running motor
|
This part is compatible with the following machines:
1613AEVS (0601613639) Plunge Router
1613EVS (0601613734) Plunge Router
1634VS (0601634739) Reciprocating Saw
1634VS (0601634739) Reciprocating Saw
1634VS (0601634839) Reciprocating Saw
1634VS (0601634839) Reciprocating Saw
1617 (0601617161) Router
1617EVS (0601617739) Router
1617 (0601617039) Shop Router
1618 (0601618039) Shop Router
1618EVS (0601618739) Shop Router
B1450 (0601613735) Plunge Router
16176 (0601617639) 2.25HP Router Motor
16181 (0601618139) 2HP Router Motor
16186 (0601618639) 2.25HP Router Motor
13020 (0601617570) Router
1613AEVS (0601613663) Router
MRF23EVS (3601F24010) 2.3 HP Fixed-Based Router
1617 (06016170A0) Router
1617 (0601617139) Router
1617EVS (0601617639) Router
1617EVS (06016176A0) Router
1618EVS (0601618639) Router
1618EVS (06016186A0) Router
This item works with the following types of products:
- • Engine
- • Reciprocating Saw
- • Router
- • Saw
Questions & Answers for Carbon Brush Set
Removed the cover plate exposing the on and off trigger. Disconnected the wires and installed them one at a time in the new switch. Closed everything up and plugged the router in and it works fine.
Disconnect the old switch leads, remove the switch
Connect the new switch leads
Disconnect the brush leads
Pull back the brush springs, remove the old brushes and install the new brushes
Connect the new brush leads
Replace the top cover
checked the brushes; they were very worn, ordered new brushes.
checked the power cord; it was good.
bypassed the start switch with a jumper wire and the unit started right up.
removed the switch and checked continuity; nothing in either position.
replaced brushes and switch and checked speed control; all was good.
replaced the cover.
The carbon brushes are spares since Bosch no longer makes this router.
Removed brushes (2 screws on each brush holder).
Removed plunge base.
Removed nut on lower shaft (recessed in bottom of housing).
Removed upper and lower bearings.
Replaced bearings and re-assembled.
Removed the switch and the brushes
Installed new parts
Everything works well now.
- 1
- 1