*This part replaces obsolete part #: 647709-01.
This is a genuine Dewalt replacement part, it is sold individually. Worn brushes frequently are the cause behind a motor running poorly.
|
This part is compatible with the following machines:
D28065N Type 1 Small Angle Grinder
D28115 Type 1 Grinder
D28115N Type 1 Grinder
D28066N (Type 1) 5in/6in Rattail Sag
D28066N (Type 2) 5in/6in Rattail Sag
D28116 (Type 1) 115mm Small Angle Grinder
DWE46066 (Type 1) 6in No Lock Rat Tail
D28065 (Type 2) Small Angle Grinder Power Tool
D28065N (Type 2) Small Angle Grinder Power Tool
D28115 (Type 2) 4-1/2 Small Angle Grinder Power Tool
D28115N (Type 2) 4-1/2 Small Angle Grinder Power Tool
This item works with the following types of products:
- • Grinder
Step-by-step instructions for removing and installing the carbon brushes on your DeWALT grinder....
December 29, 2017
|
Questions & Answers for Carbon Brush
2 Using a curved pick gently pull red brush holders out to end of spring travel
3 Lift spring allowing brush holder to swing free.
4 Replace worn carbon brush.
5 Repeat steps in reverse order.
DONE!
way cheaper than getting it repaired with a min 80 bucks to just look at it, shipping was fast and accurate. I use E Replacement parts often and would recommend them for any DIY person.
Disconnected the brushes
Pull back the brush springs and rested them on the brush holder
Removed the old brushes and install the new ones
Replaced the brush springs
Installed the brush doors
- 1
- 1
Step-by-step instructions for removing and installing the carbon brushes on your DeWALT grinder....
December 29, 2017
|