Bump Feed Knob

Very easy fix. Unscrew old bump head and screw in new one.

Unscrew the old one. Clean out the grass and dirt. Screw the new Bumper in.
Test the bumper. It took several bumps before it worked. It might be better
to clean out the entire trimmer head.
The only difficulty was grasping the old bumper to unscrew it. Wasn't much left of the old one.

Just replaced the parts that I ordered and I was back in business with my electric Ryobi weed eater/edger. I've ordered these replacement parts before and have always been very pleased.
Thank you ereplacementparts.com
Just unscrew the old bumper and release the the spool, install the new spool and screw in the new bumper
A satisfied customer
Carol from Texas

Removed broken part and replaced it with the replacement part. Just screwed off the old part and screwed on the new one. Works great now. Glad I found this site and didn't have to purchase a whole new trimmer head.

Simply unthread the old worn one, then thread on the new one.

Way to easy just screw it on.

Removed the old parts and put on the new parts and I was back in business.

Unscrewed old knob, installed new.

Removed the old bump knob and installed the new bump knob

1.Cleaned entire hub interior.
2. Lubricated appropriate areas with light grease.
3. Installed replacement parts using snap ring and C-clip.