Product Information
Description:
This is a genuine OEM replacement carbon brush designed for use with Delta and Porter Cable power equipment. It includes one (1) carbon brush with lead wire and a spring attached. Carbon brushes are a commonly replaced item on power tools. Carbon brushes through friction and use will gradually wear away and will eventually require replacement. It is recommended to replace both brushes at the same time. You would need a screwdriver and pliers to complete this job. • First remove screws holding the cover together • Remove the housing to gain access to armature and brush holder • Remove the old brush • Install the new brush • Reassemble and test your tool |
Frequently Purchased With
Compatibility
This part is compatible with the following machines:
Products Compatibility
This item works with the following types of products:
- • Sander
- • Shear
Questions & Answers for Brush
No questions have been asked yet
Repair Instructions: Submitted by Customers Like You
Tool Type:
Router
Repair Difficulty:
Hard
Time Spent Repairing:
1-2 hours
Tools Used:
Screwdriver, Pliers, Power Drill, Socket set, Wrench Set, Bearing puller
Would not turn on and needed to be rebuilt
Disassembled unit; pulled the bearings off, pressed the new ones on, cleaned the fields, replaced the brushes, gave the unit a general cleaning, reassembled and tested.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Product Information