eReplacementParts.com
877-346-4814
Porter Cable Parts
Repair Parts Home  Power Tool Parts  Porter Cable Parts  A13684 Brush and Holder Assembly
photo thumbnailphoto thumbnail360 degree photo thumbnail

Brush and Holder Assembly

Part Number: A13684
Porter CableBlack and Decker
Availability: 25+ in stock
Price: $18.73
Order within the next 11 hours
and your part ships today!
Product Information
Manufacturer: Porter Cable, Black and Decker
Product Number: A13684
Classification: Part
Weight: 0.01 lbs.
Shipping: Ships Worldwide
Description:
This is a Genuine OEM Approved replacement part designed for Routers. This assembly includes One (1) Carbon Brush with Lead Wire attached and a Metal Brush Holder. Please note Spring is Sold Separately.

Carbon motor brushes are one of the most commonly replaced power tool components. Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement. It is recommended to replace both brushes at the same time.

You would need a Screwdriver and Pliers to complete this job.
Products Compatibility

This item works with the following types of products:

  • • Engine
  • • Router
Questions & Answers

What is the part number for the spring that accompanies the brush holder assembly?
Malina for model number 8902 Type 2 asked on 2018-09-18
Hello Malina, Thank you for the question. Checking your model number 8902 Type 2, the spring is not required. Thank you for your inquiry, good luck with this repair!
I just need the brushes not the whole assembly. part # ?
Dave for model number 892 asked on 2019-07-11
Hello Dave, thank you for your question. The brushes for this unit are only available with the holder. I hope this helps.
Repair Instructions: Submitted by Customers Like You
2 of 3 people found this instruction helpful
Tool Type:
Router
Parts Used:
Brush and Holder Assembly - A13684
Repair Difficulty:
Medium
Time Spent Repairing:
15-30 minutes
Tools Used:
Screwdriver, Hex driver
Brushes were worn out
Remove the two screws holding the upper housing. Lift the upper housing away - being careful of the power switch and the rpm controller. Use the hex driver to remove the retaining screw from each of the brush holders - lift them out at an angle and remove the power cable from the quick connect. Essentially - you simply reverse the steps to install the new ones

A couple notes - make sure the springs and brushes are free to travel - they will wear over time - by design - but if they don't make good contact the router will stop running.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Reviews
5
Average Rating (out of 5):
1 Reviews
Click to filter by ratings:
5 stars
1
4 stars
0
3 stars
0
2 stars
0
1 stars
0
  • Highest Rating
  • Most Recent
< PREV
  • 1
NEXT >
  • Easy Shopping!
    Shopping for the parts I needed was much easier than I anticipated when I considered all the various parts you handle for all the various tools.
    David - August 20, 2019 Verified Purchase
    Verified Purchase
    eReplacementParts Team
    • Highest Rating
    • Most Recent
    < PREV
    • 1
    NEXT >
    Product Information
    Manufacturer: Porter Cable, Black and Decker
    Product Number: A13684
    Classification: Part
    Weight: 0.01 lbs.
    Shipping: Ships Worldwide
    eReplacementParts.com
    7036 South High Tech Dr.
    Midvale, UT 84047
    visa mastercard discover american express PayPal

    fancyboxy