Blade Control

1. Replaced broken safety handle with new one.

1) Popped the blade control into the existing holes on the lawnmower handle.
2) With a wrench, take off cover for throttle control.
3) Unhook the cable from the handle, the plate by the control (by squeezing the inside piece you can pull it through), and finally from the throttle control itself.
4) Put new cable on, hook it through the throttle control and the blade control holes, and secure it.
5) Replace cover and test.

My 11 year old son installed by him self in under 5 minutes without tools.

It fell off when it broke. New one went on by hand. No tools. Cake...............

Completely disassembled mower and cleaned all parts. Polished piston and honed cylinder. Changed all fluids and replaced spark plug and air filter. Disassembled and cleaned carb, replaced carb diaphragm and gasket. Set ignition gap and assembled mower. Replaced broken clutch lever. Mower starts first pull and runs strong

Installed new bar--very easy.

1. Remove air filter with a flat screwdriver.
2. Replace air filter, make sure you follow markings on the new air filter.
3. Tighten with a flat screwdriver.
4. Remove spark plug cable and then use a Pliers or socket to remove the Spark plug.
5. Check the gap on the old spark plug and make sure new spark plug is at the same gap size.
6. Insert new spark plug and tighten snug.
7. Loosen Blade control by flexing the handle. slide out cable and then slowly move the blade control out of another side of the handle.
8. Insert right side of blade control into the handle, then insert the cable into the left side and carefully flex handle to get the left side of blade control into the hole.

Installed the new control bar, works like a charm.

I had the mower serial number and documentation, but since the mower was about 13 years old, eReplacementParts was the ONLY place I could find this old part on the internet, including the manufacturer's site. The price was low, and I figured when I clicked on the 'add to cart' button that I would get a message 'not available', but it was available. And after I ordered, the part was delivered in about 3 days! Perfect fit, exact replacement, great bargain, fast shipment, what's not to like about this site?

1. Pulled the old cable off the motor with the pliers.
2. Attached the new cable at the throttle control on the motor.
3. Put the tips of the new blade control in the holes.
4. Attached the cable to its location on the handle.
5. Easy easy easy job.