Armature Assembly 115v 516761-7
Part Number: 516761-7
Ships within 1 business day
Product Information
Description:
| This is an authentic OEM sourced replacement component which is specially designed for use with Makita table saws The armature is a center part of an electric motor which powers the tool, over time it may wear out and begin to fail eventually requiring a replacement. Keep in mind this high-quality assembly is sold individually, it includes the durable metal armature, the plastic fan and two bearings. Make sure to refer to the appropriate diagrams of your model for the correct location and application of this part. |
Frequently Purchased With
Compatibility
Products Compatibility
This item works with the following types of products:
- • Saw
- • Table Saw
Questions & Answers for Armature Assembly 115v
No questions have been asked yet
Repair Instructions: Submitted by Customers Like You
1 of 1 people found this instruction helpful
Tool Type:
Table Saw
Parts Used:
Repair Difficulty:
Medium
Time Spent Repairing:
30-60 minutes
Tools Used:
Screwdriver, Pliers, Power Drill, Socket set, Wrench Set, Adjustable Wrench
Makita 2703 stripped it's gears
Remove motor, separate spindle, armature, etc. The only difficult part was extracting the small roller bearing from the housing. I went messing with it and it was probably fine, but once I started I was committed. If it's fine, leave it be. Spindle, armature and brushes make the old saw perform like new for 1/3rd the cost. Don't forget to grease the gears and pack gearcase with grease. If I hadn't ignored the saw, and serviced it every year or so, it probably wouldn't have worn out. Still, 15 years of service in general carpentry is a pretty good run.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Tool Type:
Table Saw
Parts Used:
Repair Difficulty:
Medium
Time Spent Repairing:
1-2 hours
Tools Used:
Screwdriver, Wrench Set, Nutdriver
Armature,and gear
Remove defective and install new one
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Tool Type:
Table Saw
Repair Difficulty:
Medium
Time Spent Repairing:
1-2 hours
Tools Used:
Screwdriver, Pliers, Rubber mallet
Did not run
Turned the table saw upside down. Removed the motor from the gear housing. Removed the brushes from the motor. Pulled the armature from out of the motor housing. Removed the baffle plate. Removed the screws hold the field. Removed the springs from around the brush holders, noting which color, went to each brush holder. Made a wiring diagram of the rest of the wires and disconnected them. Used a rubber mallet to tap on the outside of the motor housing to release the field. Reassembled in reverse order. And installed the new brushes.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Product Information
