Intake Gasket 13001642031

Echo GT-2400 grass trimmer.
A trimmer I've used for well over 30 years in my yard.. This Spring upon its start up . It ran lousy. I first removed the primer cover and primer. I put them back on after I worked on the carburetor. I did the same thing with the cap and gasket.
A carb re-build can be tricky to accomplish. So here's how I made it easy for> me.
Took pix's with my cell through-out its dismantling. Carb cleaner purchased for internal passage cleaning. Then blew out the sprayed passages with compressed air. The carburetors reassembly was a piece of cake.{all my cell pix's did garner a great resolve} Reinstalled using all new internal parts from E replacement parts. (the only internet business to buy small engine parts from) Re-set its air/ fuel mixture needles to Echo specs. Trimmer fired right up. Tweaked its low & high speed needle's a second time. Re-Set its Idle screw a tad too. GT-2400 ran as good as new. What a difference in its power curve . Trimmer went from being a throw away to a heirloom. Immediately gave the trimmer to my daughter to use in her yard and went and bought me a brand new Echo curve shaft trimmer today. Don't know if the new echo will run as good as its predecessor. My new echo has a non-adjustable carb. I just may have made a mistake in giving my old yard pal away. Oh well . I know my daughter will enjoy her daddy's sweet running trimmer.

1. Removed air cleaner
2. Disconnected fuel ine, primer and vent lines
3. Placed new gasket and carburetor on manifold
4. Tightened screws
5. Attached lines
6. Replaced air filter and cover.

Faulty carburetor was removed with two long Phillips screws that attach air filter housing and carburetor to intake manifold adapter.
New carburetor was purchased and installed along with corresponding parts from ereplacementparts.com.
Fast shipping and correct parts !

Removed carburetor and replaced parts.

Removed air filter.
Removed carb and fuel lines.
Removed gasket.
Installed new gasket.
Installed new carb and reconnected fuel lines.
Installed new air filter.
Replaced spark plug.
Trimmer runs like new!

Basically I disassembled the weed eater. And rebuilt it using the parts I purchased.
A fairly straight forward process. Took pictures along the way to have reference when re-assembling.

Removed the old parts and replaced with the new.