Spring 532105709

Removed the mower deck
Raised the front of tractor with a hoist
Hooked the spring to idler pulley assembly
then used vise grips to hook other end to side of frame.

Removed the mower deck. Identified where spring needed to be attached. hooked the spring into the idle assembly and then made a folded the string in half and ran it through the hole where the other end of spring was to hook. Hooked other end of spring into string and pull on string until the spring was hooked in hole where it went. Reattached the mower deck. Job was Done.

Had to take deck off and find where the spring went because it was not connected when found, diagram didn't show.

Remove mower deck
Elevate front tires
Put 1 end of spring in stationary point
Put vice grips onto other end of spring
Pull spring to brake pedal lever hole
Feed spring into hole
Remove vice grips
Get 4 tires to the ground
Install deck

lifted mower up with fork truck replaced spring

Removed mower deck
Removed old spring
Hooked new spring in hole toward front of tractor
Looped wire cable around remaining hook on spring
Pulled spring toward rear of tractor where slot for spring is located
(This requires you wear gloves and have good arm strength.
Be careful not to cross over any fuel lines or other items running along frame of tractor where spring is attached )
Reattach mower deck

Jacked up riding mower took off rear right tire depressed brake pedal installed return spring. Put tire back on and lowered riding mower.

Remove mower deck. Tie rope or end of spring and pull to get it to go in hole where it goes.

No brakes riding lawnmowerVery easy

Place wheel chocks behind rear wheels.
Jacked up front of mower.
Placed jack stand under machine. So I could remove Floor Jack.
I like convenience!
removed front right wheel for ease of access to frame.
Fastened bailing wire around spring loop
Crawled under right axle.
Making sure loop with wire is facing up Installed spring loop onto clutch linkage.
Slid bailing wire through the return spring slot on the front frame out the front of machine.
Used pliers to Pull wire to stretch spring to connect to front Frame slot.
Removed Bailing Wire from spring
Checked to see if clutch pedal worked OK.
Greased and Replaced wheel
Jack up front of Mower.
Removed jack stands.
Let mower down on the ground.
Test drove mower. Worked good.
Drank a beer.