Screw 5x16 V805000150

Installed full wrap handle on saw

Took off the carburetor took it apart sprayed it down with Carb cleaner ,Reassembled with the new parts supplied in the kit after I used the carb cleaned to spray out all the inner orifices finished it off with Compressed air , put in fresh gas ,installed the tune up kit ,cleaned the exhaust screen ,reassembled , hit the priming bulb a few times ,ign switch on ,choke on ,it lit right up on the first pull ,give it time to warm up ,and then went and wacked some weeds full throttle no problem .This was not my first one I've ever worked on ,Take pictures what parts go where as you go along if you have no experience ,it will save you a lot of frustration in the end .

Remove the spool and head using the notch to insert wrench temporarily to lock the head and remove the head. Easy from here. Just screw the guard back into place.

1. Removed the old spool and the screw.
2. Put the new plate in place.
3. Put the screws through.
4. Tightened the screws.