Roller Assembly B-203-1015

All I had to do was install the new plate. No tools were needed.

Super easy repair! The replacement part fit perfectly. I just unscrewed the part that hold the roller assembly in, took out the old and put in the new part. Four screws and less than 5 minutes.

Removed plate holding roller in place with two screws, fitted roller in place and put plate back on. Quick and easy.

Simple removal and reinstallation.

1. Removed the 5 screws from the brush guard to remove the brush assy and belt.
2. Rotated the adjustment knob to where slot allows removal of knob to under the vacuum.
3. Cleaned and lubricated brush assy and adjustment knob.
4. Reinstall the adjustment knob and set to LOWEST setting.
5. Removed the screw holding the brush enclosure in place.
6. Aligned roller assy axle narrow ends with slots for the assy.
7. Lowered the roller assy while moving the brush enclosure to allow the roller assy protrusion
to fit UNDER the lip sticking out of the brush enclosure.
8. Reinstall the brush enclosure screw.
9. Reinstall the brush assy with the belt ON the motor spindle.
10. Reinstall the brush guard with the 5 screws.
11. Convince wife it is now safe to use the vacuum! Demonstrate if you must!

Took off old plate put new in.

Removed and replaced.

Simple repair, was so pleased to fix my vacuum for 15 dollars as opposed to 100 for a new one. Thank you so much

Removed plate and placed rollers into slots.
Inserted the part that holds vacuum top upright

I snapped the replacement part in place. That was pretty much it!