Power Tool Care and Maintenance 101
This article suggests guidelines for power tool care and maintenance. It also describes information tools available at eReplacementParts.com.
Discussion for the Ridgid TS36120 10" Table Saw
Post a Comment
Ask a question, answer a question, or post a comment!
Question: Retaining Bearing
my saw is missing the retaining bearing which has been discontinued. where can I find a replacement or substitute? Thanks
Reply: Retaining Bearing
The manufacture did not substitute the part number 829723 Bearing Retainer, when they discontinued it. I did however searched online for it, and there were a few companies that said they had it in stock. Ya never know though.
Question: How To Fix Noise And Vibration
This problem is with my Rigid 10" Table saw (TS24121). I've had this tool for about 10 years, Right now I'm getting vibration and laud noise. Has anyone experienced this before? I think it may be a bad bearing in the Housing and Arbor (expensive).
Question: Part # 829706 (micro Adjust Asse...
part been discontinued, how do you go about replacing broken part?
Reply: Part # 829706 (micro Adjust Asse...
Unfortunately the manufacture has discontinued the 829706 Micro Adjust Assembly, and they have not come out with a replacement part. One thing that is a little frustrating, is that you can still can purchase the complete 830421 Rip Fence Assembly, that has the micro adjust assembly included in it.
Reply: Motor Rotation
In looking at the parts diagram, and where the motor is positioned on the saw. I would say that the factory set the rotation of the motor at CW.
Question: Motor 826188
What is the frame number for this motor I can't find it?????
Reply: Motor 826188
Most likely it is a 56 frame. But to make sure here is a link to a link removed Motor Frame Chart. It has all the measurements you will need to figure out what frame your motor is.
Hope this helps,
Question: Bearing Going Bad
is it better to replace the entire arbor or just the bearing? Also, is this covered under lifetime warranty?
Reply: Bearing Going Bad
You should only have to replace the bearing but if you have the life time warranty,that should be link removed Ridgid before you do any repairs and confirm this.Hope that helps.Good luck.
where can I get these discontinued parts?
A32 30442 Ring Retaining Obsolete - Not Available
Washer, .629 X 7/8 X 1/64 Obsolete - Not Available
Washer, Spring Obsolete - Not Available
I have all of these part. They are used but in good condition.
Accessories for the TS36120