How to Replace the Felt Seal on a DeWALT Angle Grinder (Model D28402)
Step-by-step instructions to easily remove and install new felt seals on a DeWalt D28402 angle grinder.
How to Diagnose a Bad Power Cord or Switch
This article outlines the basics of power tool and appliance electrical diagnosis. You can use a multimeter to test tool and appliance cords and switches, the two parts usually responsible for electri...
Power Tool Care and Maintenance 101
This article suggests guidelines for power tool care and maintenance. It also describes information tools available at eReplacementParts.com.
Discussion for the Ridgid R1001 Angle Grinder
Post a Comment
Ask a question, answer a question, or post a comment!
Question: Availability Of Part
I am a Ridgid ASC and my Ridgid parts supplier, Gardner, shows this part is still available. They also show 200216046 does replace the three discontinued parts you show above.
Reply: Availability Of Part
Thank you for bringing that to our attention. I will have it fixed on our site.
Review: Ridgid - R1001 Motor Field
It didn't last long for what little I used it. I thought it was the brushes at first but it seems to be the motor field shorted out. I only used it on floor tiles and it got hot. I cleaned the grinder after each use with an air blower. The field seems to have melted or the armature. I don't know if anyone else has had this problem.